RAV4 2WD L4-2.5L (2AR-FE) (2009)
Power Distribution Module: Service and Repair
Installation
OTHER SYSTEM: VOLTAGE INVERTER: INSTALLATION
INSTALLATION
1. INSTALL VOLTAGE INVERTER ASSEMBLY
(a) Attach the claw to install the voltage inverter assembly.
(b) Temporarily install the 2 bolts, and then tighten them in the order shown in the illustration.
Torque: 8.4 Nm (85 kgf-cm, 74 in-lbf)
(c) Connect the connector.
2. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH (w/o Rear No. 2 Seat) See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Installation
3. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH (w/ Rear No. 2 Seat) See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Installation
4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (w/o Rear No. Seat) See: Body and Frame/Interior Moulding / Trim/Headliner/Service
and Repair/Installation
5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (w/ Rear No. 2 Seat) See: Body and Frame/Interior Moulding / Trim/Headliner/Service
and Repair/Installation
6. INSTALL TETHER ANCHOR BRACKET SUB-ASSEMBLY (w/o Rear No. 2 Seat) See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Installation
7. INSTALL REAR FLOOR FINISH PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
8. INSTALL REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
9. INSTALL REAR FLOOR NO. 3 BOARD
10. INSTALL REAR FLOOR NO. 2 BOARD
11. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat) See: Body and Frame/Seats/Service and Repair/Rear No. 2 Seat
Assembly/Installation
12. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)
HINT: Use the same procedures described for the LH side.
13. INSTALL NO. 2 SEAT LEG COVER LH (w/ Rear No. 2 Seat) See: Body and Frame/Seats/Service and Repair/Rear No. 2 Seat
Assembly/Installation
14. INSTALL NO. 2 SEAT LEG COVER RH (w/ Rear No. 2 Seat)
HINT: Use the same procedures described for the LH side.
15. INSTALL NO. 2 SEAT HINGE COVER LH (w/ Rear No. 2 Seat) See: Body and Frame/Seats/Service and Repair/Rear No. 2 Seat
Assembly/Installation
16. INSTALL NO. 2 SEAT HINGE COVER RH (w/ Rear No. 2 Seat)
HINT: Use the same procedures described for the LH side.
17. INSTALL DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)
18. INSTALL REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat)
19. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
20. INSTALL REAR DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation