RAV4 2WD L4-2.5L (2AR-FE) (2009)
DISPOSAL
1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH
(a) Fully extend the shock absorber piston rod, and clamp it in a vise at an angle.
(b) Using a drill or similar tool, gradually make a hole in area A to discharge the gas inside of the absorber.
CAUTION:
-
As metal debris may be blown outward by the gas, you must
-
Wear protective glasses.
-
Cover the area being cut.
NOTE: The gas is colorless and harmless.
Removal
SUSPENSION: FRONT SHOCK ABSORBER WITH COIL SPRING: REMOVAL
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. REMOVE FRONT WHEEL
2. DISCONNECT FRONT SPEED SENSOR LH
3. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH
4. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING LH
(a) Remove the 2 bolts and 2 nuts, and disconnect the shock absorber from the steering knuckle.
HINT: While fixing the nuts in place, loosen and remove the bolts.
(b) Remove the 3 nuts and shock absorber with coil spring.
Installation
SUSPENSION: FRONT SHOCK ABSORBER WITH COIL SPRING: INSTALLATION
INSTALLATION
HINT: