RAV4 2WD L4-2.5L (2AR-FE) (2009)
joint angle.
No. 1 Joint Angle:
(c) Using SST, measure the angle of the intermediate shaft (angle A) and the angle of the propeller shaft (angle B).
SST: 09370-50010
(1) Subtract the measured angle of the propeller shaft (angle B) from the measured angle of the intermediate shaft (angle A) to obtain the No. 2
joint angle.
No. 2 Joint Angle:
(d) Using SST, measure the angle of the propeller shaft (angle B) and the angle of the rear differential (angle C).
SST: 09370-50010
(1) Subtract the measured angle of the propeller shaft (angle B) from the measured angle of the rear differential (angle C) to obtain the No. 3
joint angle.
No. 3 Joint Angle:
3. ADJUST JOINT ANGLE
(a) If the measured angle of the propeller shaft is not within the specified range, or there is vibration or noise, use the following procedure to
adjust the propeller shaft.
(1) Support the propeller shaft with a jack.
(2) Remove the 2 center bearing mounting bolts.
(3) Slowly lower the jack and disconnect the center bearing.
(4) Select an appropriate adjusting washer thickness from the table below, and obtain a washer set.
Standard adjusting washer: