RAV4 2WD V6-3.5L (2GR-FE) (2006)
Cruise Control Switch: Service and Repair
CRUISE CONTROL MAIN SWITCH
REMOVAL
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE STEERING PAD ASSEMBLY
3. REMOVE CRUISE CONTROL MAIN SWITCH
a. Disconnect the connector.
b. Remove the 2 screws and switch.
INSTALLATION
1. INSTALL CRUISE CONTROL MAIN SWITCH
a. Install the switch with the 2 screws.
Torque: 1.7 to 3.0 N.m (17.34 to 30.60 kgf.cm, 15.04 to 26.55 in.lbf)
b. Connect the connector.
2. INSTALL STEERING PAD ASSEMBLY
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. CHECK SRS WARNING LIGHT
a. Check the SRS warning light.