RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
Wiper Switch: Testing and Inspection
Intermittent Wiper Operation
INSPECT INTERMITTENT WIPER OPERATION
1. Turn the wiper switch to the INT position. A
2. Turn the intermittent time control switch to the FAS position.
3. Connect the positive (+) lead from the battery to terminal 17 and the negative (-) lead to terminal 16.
4. Connect the positive (+) lead from the voltmeter to terminal 7 and the negative (-) lead to terminal 16, check that the meter needle indicates battery
positive voltage.
5. After connecting terminal 2 to terminal 1 7, connect to terminal 16.
Then, check that the voltage rises from 0 V to battery positive voltage within the times, as shown in the table.
If operation is not as specified, replace the switch.