RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
b. Using SST and a press, press in the oil seal.
SST 09612 - 22011
NOTICE: Make sure to install the oil seal facing the correct direction.
c. Using snap ring pliers, install a new snap ring to the rack housing.
10. Install dust cover.
11. Install spacer and bearing. Install the spacer and a new bearing into the rack housing.
12. Install lock nut.
a. Using SST to stop the control valve shaft rotating, torque a new nut.
SST 09616 - 00010
Torque: 12 Nm (9 ft. lbs.)
b. Turn C of SST to obtain dimension A, then set SST, as shown.
SST 09613 - 12020
Dimension A: 16.5 - 17.0 mm (0.65 - 0.67 inch)
c. Stake the nut by turning B of SST until it touches the spacer of SST.
13. Install rack housing cap.
a. Apply sealant to 2 or 3 threads of the cap.
Sealant: Part No.08833 - 00080, THREE BOND 1344, LOCTITE 242 or equivalent.
b. Torque the cap.
Torque: 69 Nm (51 ft. lbs.)
14. Install rack guide seat, rack guide, rack guide spring and rack guide spring cap.