RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
RH: Using a press, remove the dust cover from the center drive shaft.
LH: Using Special Service Tool (SST) and a press, remove the dust cover from the inboard joint tulip.
SST 09950 - 00020
7. Remove No. 2 dust deflector.
a. Mount outboard joint shaft in a soft jaw vise.
b. Using a screwdriver and hammer, remove the No. 2 dust deflector.
NOTICE: Be careful not to damage the ABS speed sensor rotor.
ASSEMBLY
1. Install No. 2 dust deflector.
Using SST and a press, install a new No. 2 dust deflector.
2. Install dust cover.