RAV4 4WD V6-3.5L (2GR-FE) (2006)
Fuel Pressure Pulsation Damper: Service and Repair
REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
3. REMOVE ENGINE ASSEMBLY
a. Remove the engine.
4. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
5. REMOVE FUEL PRESSURE PULSATION DAMPER
a. Remove the clip.
b. Pull out the fuel pressure pulsation damper from the fuel delivery pipe.
INSTALLATION
1. INSTALL FUEL PRESSURE PULSATION DAMPER
a. Apply a light coat of spindle oil or gasoline to a new O-ring, and install it to the pulsation damper.
b. Install the pulsation damper to the fuel delivery pipe.
c. Install the clip.
2. INSTALL INTAKE AIR SURGE TANK ASSEMBLY
3. INSTALL ENGINE ASSEMBLY
a. Install the engine.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL