RAV4 4WD V6-3.5L (2GR-FE) (2006)
3. INSTALL FRONT DRIVE SHAFT DUST COVER LH
a. Using SST and a press, press in a new drive shaft dust cover.
SST 09527-10011
NOTICE:
^
The dust cover should be installed completely.
^
Be careful not to damage the dust cover.
4. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING LH
a. Install a new hole snap ring.
5. INSPECT FRONT DRIVE SHAFT
6. INSTALL FRONT AXLE OUTBOARD JOINT BOOT
HINT: Before installing the boots, wrap the spline of the drive shaft with vinyl tape to prevent the boots from being damaged.
a. Install new parts to the outboard joint shaft in the following order.
1. No. 2 outboard joint boot clamp
2. Outboard joint boot
3. Outboard joint boot clamp
b. Pack the outboard joint shaft and boot with grease from the boot kit.
Standard grease capacity: 190 to 200 g (6.7 to 7.1 oz.)
7. INSTALL FRONT AXLE OUTBOARD JOINT BOOT LH NO.2 CLAMP
CAUTION: Wear protective gloves while performing the operation and be careful to avoid cutting your hands or other body parts.
a. Install a new boot clamp to the outboard joint boot and temporarily bend the lever.
NOTICE:
^
When temporarily bending the lever, make sure not to deform the band and lever.
^
Set the clamp correctly in the guide groove and align it with the interior of the vehicle as much as possible.