Sequoia 2WD V8-4.6L (1UR-FE) (2010)
(d) Remove the 2 screws and lumbar support adjuster assembly.
(e) Detach the 3 claws and remove the bush from the seat frame.
Installation
SEAT: LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Power Seat): INSTALLATION
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT
*
Use the same procedure for the LH side and RH side.
*
The procedure listed below is for the LH side.
1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (w/ Climate Control Seat System)
(a) Attach the 3 claws to install the bush.
(b) Install the lumbar support adjuster assembly with the 2 screws.
(c) Connect the connector.
(d) Attach the 4 hooks to install the seatback spring.