Sequoia 2WD V8-4.6L (1UR-FE) (2010)
Spoiler: Overhaul
Disassembly
EXTERIOR PANELS / TRIM: REAR SPOILER: DISASSEMBLY
1. REMOVE CENTER STOP LIGHT ASSEMBLY
(a) Remove the 2 screws and the center stop light.
2. REMOVE CENTER STOP LIGHT SOCKET AND WIRE
(a) Using string, tie the harness section of the center stop light socket and wire.
(b) Remove the center stop light socket and wire from the rear spoiler.
Reassembly
EXTERIOR PANELS / TRIM: REAR SPOILER: REASSEMBLY
1. INSTALL CENTER STOP LIGHT SOCKET AND WIRE
(a) Pass a piece of string through the new rear spoiler.
(b) Tie the string to the center stop light socket and wire.
(c) Pull the string and pass the center stop light socket and wire through the inside of the rear spoiler. Then pull the connector through the opening
of the rear spoiler.
2. INSTALL CENTER STOP LIGHT ASSEMBLY