Sequoia 2WD V8-4.6L (1UR-FE) (2010)
![background image](/toyota/sequoia_2wd/v8-4.6l_(1ur-fe)/Page-2178004.png)
(c) Install the O-ring to the cap.
(d) Using a 14 mm socket hexagon wrench, install the cap to the modulator.
Torque : 2.9 Nm (30 kgf-cm, 26 in-lbf)
2. INSTALL COOLER CONDENSER ASSEMBLY
(a) Install the cooler condenser with the 2 bolts, as shown in the illustration.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
3. CONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
(a) Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring on the air conditioning tube and accessory.
(d) Connect the air conditioning tube and accessory on the cooler condenser with the 2 bolts.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
NOTICE:
*
When tightening the bolt, do not allow any tools to contact the pipe.
*
When tightening the bolt, hold a part of the pipe near the connector.
4. CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
(a) Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.