Sequoia 2WD V8-4.6L (1UR-FE) (2010)
Hazard Warning Flasher: Service and Repair
Removal
LIGHTING (EXT): TURN SIGNAL FLASHER ASSEMBLY: REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE LH
HINT
Use the same procedure as for the RH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal.
2. REMOVE COWL SIDE TRIM BOARD LH
HINT
Use the same procedure as for the RH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal.
3. REMOVE INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Removal
5. REMOVE TURN SIGNAL FLASHER ASSEMBLY
(a) Disconnect the connector.
(b) Remove the nut and turn signal flasher.