Sequoia 2WD V8-4.6L (1UR-FE) (2010)
![background image](/toyota/sequoia_2wd/v8-4.6l_(1ur-fe)/Page-3169002.png)
2. REMOVE BACK DOOR SIDE GARNISH RH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
3. REMOVE BACK DOOR SIDE GARNISH LH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
4. REMOVE BACK DOOR STRAP COVER See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
5. REMOVE BACK DOOR PULL STRAP See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Disassembly
7. REMOVE BACK DOOR SERVICE HOLE COVER See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Disassembly
8. REMOVE BACK DOOR LOCK PROTECTOR SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Disassembly
9. REMOVE W/MOTOR BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)
(a) Disconnect the connector.
(b) Disengage the clamp.
(c) Remove the 3 bolts and back door lock.
10. REMOVE W/MOTOR BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)
(a) Disconnect the connector.
(b) Disengage the clamp.
(c) Remove the 4 bolts and back door lock.
Installation
LIGHTING (INT): BACK DOOR COURTESY SWITCH: INSTALLATION
1. INSTALL W/MOTOR BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)
(a) Install the back door lock with the 3 bolts.