Sequoia 2WD V8-4.6L (1UR-FE) (2010)
![background image](/toyota/sequoia_2wd/v8-4.6l_(1ur-fe)/Page-3214001.png)
Turn Signal Lamp: Service and Repair
Removal
LIGHTING (EXT): SIDE TURN SIGNAL LIGHT ASSEMBLY: REMOVAL
HINT
*
Use the same procedure for both the RH and LH sides.
*
The procedure described below is for the LH side.
1. REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY
(a) Push the upper part of the mirror surface and tilt it.
(b) Apply protective tape, as shown in the illustration.
(c) Using a moulding remover, push the bottom of the glass upwards as shown in the illustration. Slide the glass upwards to detach the 4 claws,
and remove the outer rear view mirror glass.
(d) Disconnect the connectors.