Sequoia 2WD V8-4.6L (1UR-FE) (2010)
(1) Disconnect the connector (yellow colored) from the front seat side airbag.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
(2) Connect SST connector to the front seat side airbag connector.
SST : 09082-00700
SST : 09082-00820
NOTICE:
To avoid damaging SST connector and wire harness, do not lock the secondary lock of the twin lock.
(3) Move SST at least 10 m (32.8 ft.) away from the vehicle front side window.
(4) Maintaining enough clearance for SST wire harness in the front side window, close all doors and windows of the vehicle.
NOTICE:
Take care not to damage SST wire harness.
(5) Connect the red clip of SST to the battery positive (+) terminal and the black clip of SST to the battery negative (-) terminal.
(e) Deploy the airbag.
(1) Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
(2) Press SST activation switch and deploy the airbag.
CAUTION:
*
When deploying the airbag, make sure that no one is near the vehicle.
*
The front seat side airbag becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.
*
Use gloves and safety glasses when handling a front seat side airbag with a deployed airbag.
*
Do not apply water to a front seat side airbag with a deployed airbag.
*
Always wash your hands with water after completing the operation.
HINT
The airbag is deployed as the LED of SST activation switch comes on.