Sequoia 2WD V8-4.6L (1UR-FE) (2010)
Acceleration/Deceleration Sensor: Service and Repair
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND DECELERATION SENSOR: INSTALLATION
1. INSTALL YAW RATE SENSOR
(a) Connect the sensor connector (labeled A), and then attach the clamp (labeled B) to the hole of the sensor bracket.
(b) Install the yaw rate sensor with the 2 nuts (labeled C).
Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)
NOTICE:
*
Make sure that the sensor is oriented correctly.
*
If the sensor is dropped, replace it.
*
Securely connect the connector.
*
When installing the sensor, avoid impacts to the sensor.
2. INSTALL REAR CONSOLE BOX ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Front Console Box/Installation
3. INSTALL CONSOLE BOX CARPET See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Front Console Box/Installation
4. INSTALL REAR CONSOLE BOX POCKET See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Front Console Box/Installation
5. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Front Console Box/Installation
6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
and Replacement/Front Console Box/Installation
7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Front Console Box/Installation
8. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
(a) Perform the yaw rate sensor zero point calibration See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Programming and Relearning.
9. CHECK YAW RATE SENSOR SIGNAL
(a) Check the yaw rate sensor signal See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and