Sequoia 2WD V8-4.6L (1UR-FE) (2010)
Ride Height Sensor: Service and Repair
Installation
SUSPENSION CONTROL: HEIGHT CONTROL SENSOR: INSTALLATION
1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
(a) Install the rear height control sensor with the nut.
Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)
(b) Connect the rear height control sensor connector.
(c) Align the matchmark on the rear height control sensor link and bracket.
(d) Install the rear height control sensor link with the nut.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
2. ADJUST VEHICLE HEIGHT
See: Steering and Suspension/Suspension/Adjustments