Sequoia 2WD V8-4.6L (1UR-FE) (2010)
Front Steering Knuckle: Service and Repair
Removal
AXLE AND DIFFERENTIAL: STEERING KNUCKLE: REMOVAL
HINT
*
Use the same procedure for the LH side and RH side.
*
The procedure listed below is for the LH side.
1. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
(a) Remove the front axle hub See: Wheel Hub/Service and Repair/Removal and Replacement/Front Axle Hub/Removal.
2. DISCONNECT FRONT SPEED SENSOR LH
(a) Remove the clip and bolt.
(b) Disconnect the speed sensor from the steering knuckle.
3. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
(a) Remove the cotter pin and nut.
(b) Using SST, disconnect the tie rod end LH from the steering knuckle.
SST : 09610-20012
NOTICE:
*
Do not damage the front disc brake dust cover.
*
Do not damage the ball joint dust cover.
*
Do not damage the steering knuckle.
4. DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH See: Control Arm/Service and Repair/Removal and Replacement/Front
Lower Suspension Arm/Removal
5. REMOVE STEERING KNUCKLE LH
(a) Support the front suspension lower arm LH with a jack.
(b) Remove the clip and the nut.
(c) Using SST, disconnect the upper ball joint from the steering knuckle.