Sequoia 2WD V8-4.7L (2UZ-FE) (2003)
/Page-956001.png)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Rear
REMOVAL
1. DISCONNECT SPEED SENSOR CONNECTOR
2. REMOVE SPEED SENSOR
a. Remove the 6 resin clips holding the sensor wire harness.
b. Remove the bolt and speed sensor from the axle carrier.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
INSTALLATION
Installation is In the reverse order of removal.
HINT: After installation, check speed sensor signal.