Sequoia 4WD V8-4.6L (1UR-FE) (2010)
/Page-2556003.png)
4. REMOVE NO. 1 ULTRASONIC SENSOR
(a) Disconnect the sensor connector.
(b) While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.
HINT
The types of the claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the
sensor.
5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER
(a) Disengage the 2 claws and remove the ultrasonic sensor retainer from the rear bumper.
6. REMOVE NO. 2 ULTRASONIC SENSOR
(a) Disconnect the sensor connector.
(b) While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.
HINT
The types of claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting removing the
sensor.
7. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER
(a) Disengage the 2 claws and remove the ultrasonic sensor retainer from the rear bumper.