Sequoia 4WD V8-4.6L (1UR-FE) (2010)
*
The procedures listed below are for the LH side.
1. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH RH See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Service and Repair/Disassembly
2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG RH See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Disassembly
3. REMOVE FRONT UPPER ARMREST BASE PANEL RH See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Disassembly
4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Disassembly
5. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
(a) Disconnect the speaker connector.
(b) Remove the 4 screws.
(c) Disengage the 3 claws and remove the speaker.
NOTICE:
Do not touch the cone part of the speaker.
6. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 14 Speakers)
(a) Disengage the 3 claws and remove the speaker.
NOTICE:
Do not touch the cone part of the speaker.
Installation
AUDIO / VIDEO: FRONT DOOR SPEAKER: INSTALLATION
HINT