Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Front Door Panel: Service and Repair
Disassembly
DOOR / HATCH: FRONT DOOR: DISASSEMBLY
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system
before servicing See: Restraint Systems/Air Bag Systems/Service Precautions.
HINT
*
Use the same procedure for both the RH and LH sides.
*
The procedure described below is for the RH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers)
(a) Disengage the 3 clips and remove the front door lower frame bracket garnish.
(b) Disconnect the connector.
3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
(a) Disengage the 3 clips and remove the front door lower frame bracket garnish.
4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
(a) Using a moulding remover, disengage the 4 claws and remove the front door inside handle bezel plug.
5. REMOVE FRONT ARMREST BASE UPPER PANEL