Sequoia 4WD V8-4.6L (1UR-FE) (2010)
(b) Install a new No. 1 roof side mark as shown in the illustration.
Installation Position:
NOTICE:
Install the No. 1 roof side mark in an environment where the ambient temperature is over 20°C (68°F). If it is below 20°C (68°F),
using an infrared light, heat the rear door panel and the No. 1 roof side mark up to 20 to 30°C (68 to 86°F) and install the No. 1 roof
side mark.
6. INSTALL NO. 1 ROOF SIDE MARK
(a) Clean the attachment surface.
(1) Using an infrared light, heat the double-sided adhesive tape remaining on the rear door panel.
HINT
Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.
(2) Using a piece of cloth, rub the double-sided adhesive tape off the rear door panel while it is hot from the infrared light.
NOTICE:
Installing the No. 1 roof side mark while any double-sided tape remains on the rear door panel may cause adhesion failure. Therefore,
completely remove the double-sided tape.
(3) Using a non-residue solvent, clean the attachment surface.