toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Front Door Lock|Page 9155 > < Front Door Lock|Page 9153
Page 3
background image

4. REMOVE FRONT ARMREST BASE UPPER PANEL   See: Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Disassembly

5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY   See: Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Disassembly

6. REMOVE FRONT DOOR TRIM NO. 1 BRACKET   See: Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Disassembly

7. REMOVE FRONT DOOR SERVICE HOLE COVER   See: Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Disassembly

8. REMOVE FRONT DOOR GLASS RUN   See: Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Disassembly

9. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY   See: Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Disassembly

10. REMOVE FRONT DOOR FRAME REAR LOWER SUB-ASSEMBLY   See: Doors, Hood and Trunk/Doors/Front Door/Service and

Repair/Disassembly

11. REMOVE FRONT DOOR LOCK

(a) Using a "TORX" socket wrench T30, remove the 3 screws.

(b) Slide the front door lock downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock and

cables as a unit.

(c) Remove the door lock wire harness seal from the front door lock.

(d) Remove the front door lock remote control cable.

(e) Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.

(f) Remove the front door inside locking cable.

Front Door Lock|Page 9155 > < Front Door Lock|Page 9153