Sequoia 4WD V8-4.6L (1UR-FE) (2010)
(e) Engage the claw and close the cover.
(f) Install a new door lock wire harness seal on to the rear door lock.
(g) Insert the rear door lock into the rear door outside handle release plate, and set it to the rear door panel.
(h) Make sure that the rear door outside handle frame lock.
(i) Apply adhesive to the threads of the screws.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
(j) Using a "TORX" socket wrench T30, install the rear door lock with the 3 screws.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY See: Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Reassembly
3. INSTALL REAR DOOR WINDOW FRAME REAR LOWER SUB-ASSEMBLY See: Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Reassembly
4. INSTALL REAR DOOR GLASS RUN See: Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Reassembly
5. INSTALL REAR DOOR SERVICE HOLE COVER See: Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Reassembly
6. INSTALL REAR DOOR TRIM NO. 2 BRACKET See: Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Reassembly
7. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY See: Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Reassembly
8. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG See: Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Reassembly
9. INSTALL REAR DOOR ARMREST BASE UPPER PANEL See: Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Reassembly
10. INSTALL REAR DOOR FRAME GARNISH See: Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Reassembly