Sequoia 4WD V8-4.6L (1UR-FE) (2010)
/Page-2943005.png)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(2) If the result is not as specified, replace the seatback heater.
Seat Heater System
SEAT: SEAT HEATER SYSTEM: ON-VEHICLE INSPECTION
1. INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH (for Front Seat)
(a) Disconnect the X12 heater control connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) If the result is not as specified, there may be a malfunction on the wire harness side.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(e) If the result is not as specified, there may be a malfunction on the wire harness side.