Sequoia 4WD V8-4.6L (1UR-FE) (2010)
2. REMOVE COWL SIDE TRIM BOARD LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal
3. REMOVE INSTRUMENT SIDE PANEL LH See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal
4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH See: Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
5. REMOVE LOWER STEERING COLUMN COVER See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Wiper
Switch/Service and Repair/Removal
6. REMOVE UPPER STEERING COLUMN COVER See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Wiper
Switch/Service and Repair/Removal
7. REMOVE UNLOCK WARNING SWITCH
(a) Disconnect the connector.
(b) Insert the key into the ignition key cylinder.
(c) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the unlock warning switch.
Installation
DOOR LOCK: UNLOCK WARNING SWITCH: INSTALLATION
1. INSTALL UNLOCK WARNING SWITCH
(a) Engage the 2 claws and install the unlock warning switch.
(b) Connect the connector.
2. INSTALL UPPER STEERING COLUMN COVER See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Wiper
Switch/Service and Repair/Installation
3. INSTALL LOWER STEERING COLUMN COVER See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Wiper
Switch/Service and Repair/Installation
4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH See: Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation
5. INSTALL INSTRUMENT SIDE PANEL LH See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Installation
6. INSTALL COWL SIDE TRIM BOARD LH See: Interior Moulding / Trim/Headliner/Service and Repair/Installation
7. INSTALL FRONT DOOR SCUFF PLATE LH See: Interior Moulding / Trim/Headliner/Service and Repair/Installation