Sequoia 4WD V8-4.6L (1UR-FE) (2010)
/Page-1664001.png)
Brake Fluid Pump Relay: Testing and Inspection
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: RELAY: ON-VEHICLE INSPECTION
1. CHECK STOP LIGHT CONTROL RELAY (BRK NO. 1, BRK NO. 2)
(a) Remove the 2 stop light control relays from the engine room relay block.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) If the result is not as specified, replace the relay.
(d) Install the 2 stop light control relays.