Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Brake Pedal Assy: Service and Repair
Removal
BRAKE SYSTEM (OTHER): BRAKE PEDAL: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
2. REMOVE FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
3. REMOVE COWL SIDE TRIM BOARD LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
4. REMOVE INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
5. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release
Cable/Service and Repair/Removal
6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Removal
7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Knee Airbag Assembly (for Driver Side)/Removal
8. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
(a) Remove the bolt and defroster nozzle duct.
9. REMOVE PUSH ROD PIN
(a) Remove the clip and push rod pin from the brake pedal lever.
10. REMOVE STOP LIGHT SWITCH ASSEMBLY See: Lighting and Horns/Brake Light Switch/Service and Repair/Removal
11. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
(a) Remove the stop light switch mounting adjuster.
12. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY
(a) Remove the brake pedal return spring.
(b) Remove the bolt from the No. 3 brake pedal bracket.