Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Parking Brake Cable: Service and Repair
Removal
PARKING BRAKE: PARKING BRAKE CABLE: REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
2. REMOVE COWL SIDE TRIM BOARD LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
3. REMOVE INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release
Cable/Service and Repair/Removal
5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Removal
6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Knee Airbag Assembly (for Driver Side)/Removal
7. RELEASE PARKING BRAKE PEDAL
8. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY See: Parking Brake Pedal/Service and Repair/Removal and
Replacement/Removal
9. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for 1UR-FE) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust
Pipe/Service and Repair/Removal
10. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for 3UR-FE) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust
Pipe/Service and Repair/Removal
11. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for 3UR-FBE) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust
Pipe/Service and Repair/Removal
12. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY
(a) Remove the adjustment nut and lock nut (labeled A).
(b) Remove the bolt (labeled B) and cable retainer.
(c) Remove the nut (labeled C) and clamp from the body.
(d) Disconnect the clamp (labeled D) from the No. 1 parking brake cable.
(e) Remove the 2 bolts (labeled E) and No. 1 parking brake cable from the inside of the vehicle.
NOTICE:
Do not bend and twist the parking brake cable.