Sequoia 4WD V8-4.6L (1UR-FE) (2010)
![background image](/toyota/sequoia_4wd/v8-4.6l_(1ur-fe)/Page-900001.png)
Radiator: Service and Repair
Removal
1UR-FE COOLING: RADIATOR: REMOVAL
1. REMOVE FRONT BUMPER COVER
(a) Remove the front bumper cover See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and Replacement/Removal.
2. REMOVE NO.1 ENGINE UNDER COVER See: Engine/Engine Lubrication/Engine Oil/Service and Repair/Replacement
3. REMOVE ENGINE COOLANT See: Coolant/Service and Repair
4. REMOVE V-BANK COVER SUB-ASSEMBLY See: Engine/Service and Repair/Removal and Replacement/Engine Assembly/Removal
5. REMOVE AIR CLEANER ASSEMBLY See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair/Removal
6. REMOVE INLET RADIATOR HOSE
(a) Remove the radiator hose.
7. REMOVE FAN SHROUD
(a) Loosen the 4 nuts holding the fluid coupling fan.
(b) Remove the fan generator V-belt See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal.
(c) Disconnect the reservoir hose from the upper radiator tank.
(d) Remove the 2 bolts holding the fan shroud.
(e) Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.
NOTICE:
Be careful not to damage the radiator core.
(f) Remove the fan pulley from the fan bracket.
8. DISCONNECT OUTLET RADIATOR HOSE See: Thermostat/Service and Repair/Removal
9. REMOVE RADIATOR SIDE DEFLECTOR RH
(a) Using a clip remover, remove the 6 clips and side deflector.