Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Water Pump: Service and Repair
Removal
1UR-FE COOLING: WATER PUMP: REMOVAL
1. REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT
(a) Remove the water inlet with thermostat See: Thermostat/Service and Repair/Removal.
2. REMOVE INLET RADIATOR HOSE See: Radiator/Service and Repair/Removal
3. REMOVE FAN SHROUD See: Radiator/Service and Repair/Removal
4. REMOVE FRONT FENDER APRON SEAL LH See: Exhaust System/Exhaust Manifold/Service and Repair/Removal
5. DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Oil Cooler) See: Heating and Air Conditioning/Compressor HVAC/Service and
Repair/Removal and Replacement/Removal
6. REMOVE WATER BY-PASS PIPE (w/ Oil Cooler)
(a) Remove the 2 bolts.
(b) Disconnect the 4 water hoses and remove the water by-pass pipe.
7. REMOVE NO. 1 WATER BY-PASS HOSE
(a) Remove the water by-pass hose.
8. DISCONNECT NO. 8 WATER BY-PASS HOSE
(a) Disconnect the water by-pass hose.
9. DISCONNECT NO. 5 WATER BY-PASS HOSE
(a) Disconnect the water by-pass hose.
10. REMOVE WATER INLET HOUSING