Sequoia 4WD V8-4.6L (1UR-FE) (2010)
(b) Uniformly loosen and remove the 10 bearing cap bolts in the sequence shown in the illustration.
(c) Uniformly loosen and remove the 18 bearing cap bolts in the sequence shown in the illustration.
NOTICE:
Uniformly loosen the bolts while keeping the camshaft level.
(d) Remove the 6 bearing caps.
HINT
Arrange the removed parts in the correct order.
(e) Remove the No. 1 and No. 2 camshafts.
13. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY RH
(a) Remove the camshaft housing by prying between the cylinder head and camshaft housing with a screwdriver.
HINT
Tape the screwdriver tip before use.
NOTICE:
Be careful not to damage the contact surfaces of the cylinder head and camshaft housing.
Installation
1UR-FE ENGINE MECHANICAL: CAMSHAFT (for Bank 2): INSTALLATION
1. INSTALL CAMSHAFT BEARING CAP RH