Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Front Crankshaft Seal: Service and Repair
Removal
1UR-FE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: REMOVAL
1. REMOVE V-BANK COVER SUB-ASSEMBLY See: Service and Repair/Removal and Replacement/Engine Assembly/Removal
2. REMOVE NO. 1 ENGINE UNDER COVER See: Engine Lubrication/Engine Oil/Service and Repair/Replacement
3. DRAIN ENGINE COOLANT See: Cooling System/Coolant/Service and Repair
4. REMOVE INLET RADIATOR HOSE See: Cooling System/Radiator/Service and Repair/Removal
5. REMOVE FAN AND GENERATOR V BELT See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal
6. REMOVE FAN SHROUD See: Cooling System/Radiator/Service and Repair/Removal
7. DISCONNECT FRONT STABILIZER BAR
(a) Remove the 4 bolts, 2 stabilizer brackets and 2 stabilizer bushes. Then disconnect the stabilizer bar.
8. DISCONNECT COOLER COMPRESSOR ASSEMBLY See: Engine Lubrication/Oil Pump/Service and Repair/Removal and
Replacement/Removal
9. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY See: Engine Lubrication/Engine Oil/Service and Repair/Replacement
10. REMOVE WATER BY-PASS PIPE (w/ Oil Cooler) See: Water Pump/Service and Repair/Removal
11. REMOVE NO. 1 OIL COOLER BRACKET (w/ Oil Cooler) See: Engine Lubrication/Oil Cooler/Service and Repair/Removal and
Replacement/Removal
12. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY See: Engine Lubrication/Oil Cooler/Service and Repair/Removal and
Replacement/Removal
13. REMOVE CRANKSHAFT PULLEY See: Engine Lubrication/Oil Pump/Service and Repair/Removal and Replacement/Removal
14. REMOVE CRANKSHAFT TIMING GEAR KEY
(a) Remove the crankshaft timing gear key from the crankshaft.
15. REMOVE FRONT CRANKSHAFT OIL SEAL
(a) Using a screwdriver, pry out the oil seal.