Sequoia 4WD V8-4.6L (1UR-FE) (2010)
(a) Remove the 2 bolts and air conditioning tube from the cooler condenser.
(b) Remove the O-ring from the air conditioning tube.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
7. REMOVE COOLER CONDENSER ASSEMBLY
(a) Remove the 2 bolts.
(b) Remove the cooler condenser, as shown in the illustration.
NOTICE:
Do not damage the cooler condenser when removing the cooler condenser.
Installation
HEATING / AIR CONDITIONING: CONDENSER (w/o Air Cooled Transmission Oil Cooler): INSTALLATION
1. INSTALL COOLER CONDENSER ASSEMBLY
(a) Install the cooler condenser with the 2 bolts, as shown in the illustration.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
NOTICE:
Do not damage the cooler condenser when installing the condenser.
HINT
If a new cooler condenser is installed, add compressor oil to the condenser as follows.
Capacity:
Add 40 cc (1.35 fl. oz.)