Sequoia 4WD V8-4.6L (1UR-FE) (2010)
License Plate Lamp: Service and Repair
Installation
LIGHTING (EXT): LICENSE PLATE LIGHT ASSEMBLY: INSTALLATION
1. INSTALL LICENSE PLATE LIGHT BULB
(a) Install the license plate light bulb into the light socket.
2. INSTALL LICENSE PLATE LIGHT ASSEMBLY
(a) Tighten the 4 screws.
(b) Connect the 4 harness clamps and install the license plate light.
3. INSTALL REAR TELEVISION CAMERA ASSEMBLY See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist
Systems/Rear Vision Camera/Service and Repair/Installation
4. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
5. INSTALL BACK DOOR SERVICE HOLE COVER See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Reassembly
6. INSTALL BACK DOOR TRIM BOARD ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Reassembly
7. INSTALL BACK DOOR PULL STRAP See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Reassembly
8. INSTALL BACK DOOR STRAP COVER See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Reassembly
9. INSTALL BACK DOOR SIDE GARNISH LH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Reassembly
10. INSTALL BACK DOOR SIDE GARNISH RH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Reassembly
11. INSTALL BACK DOOR CENTER GARNISH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Reassembly