Sequoia 4WD V8-4.6L (1UR-FE) (2010)
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- CONNECT CONNECTOR
OK -- Continue to next step.
14. CHECK FOR OPEN IN CAN BUS MAIN WIRE (NO. 1 JUNCTION CONNECTOR - NO. 4 JUNCTION CONNECTOR)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN MAIN WIRE OR CONNECTOR (NO. 1 JUNCTION CONNECTOR - NO. 4 JUNCTION
CONNECTOR)
OK -- REPLACE NO. 4 JUNCTION CONNECTOR
15. CONNECT CONNECTOR
(a) Reconnect the O41 No. 4 junction connector.
NEXT -- Continue to next step.
16. CHECK FOR OPEN IN CAN BUS MAIN WIRE (COMBINATION METER ECU - NO. 4 JUNCTION CONNECTOR)
(a) Disconnect the H37 combination meter ECU connector.