Sequoia 4WD V8-4.6L (1UR-FE) (2010)
/Page-1113025.png)
(3) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(4) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(b) w/o AVS
(1) Reconnect the cable to the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
(2) Disconnect the O19 suspension control ECU connector.
(3) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(4) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE SUSPENSION CONTROL ECU See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays
and Modules - Suspension/Suspension Control Module/Service and Repair/Removal
4WD Control ECU Communication Stop Mode
NETWORKING: CAN COMMUNICATION SYSTEM: 4WD Control ECU Communication Stop Mode
- 4WD Control ECU Communication Stop Mode