Sequoia 4WD V8-4.6L (1UR-FE) (2010)
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
HINT
*
Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30
cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification
See: Service Precautions.
*
Make sure SST and the wrench are connected in a straight line.
3. INSTALL PROPELLER SHAFT HEAT INSULATOR (for 4WD) See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Removal and Replacement/Front Propeller Shaft Assembly/Installation
4. INSPECT FOR EXHAUST GAS LEAK See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and Repair/Installation