Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Knock Sensor: Service and Repair
Installation
1UR-FE ENGINE CONTROL: KNOCK SENSOR: INSTALLATION
1. INSTALL KNOCK SENSOR
(a) Install the 4 sensors with the 4 bolts so that the sensors are angled as shown in the illustration.
Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)
NOTICE:
The acceptable installation angle of the sensor is between 10° upward and downward from the horizontal position.
(b) Connect the 4 sensor connectors.
2. INSTALL SEPARATOR CASE
(a) Install the separator case with the 4 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
3. INSTALL INTAKE MANIFOLD
(a) Install the intake manifold See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Installation.