Sequoia 4WD V8-4.6L (1UR-FE) (2010)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
HINT
*
Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30
cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification
See: Service Precautions.
*
Make sure SST and the wrench are connected in a straight line.
4. INSTALL PROPELLER SHAFT HEAT INSULATOR (for 4WD) See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Removal and Replacement/Front Propeller Shaft Assembly/Installation
5. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(a) Install a new gasket and the front exhaust pipe to the exhaust manifold RH with 3 new nuts.
Torque : 54 Nm (554 kgf-cm, 40 ft-lbf)
(b) Connect the air fuel ratio sensor connector.
(c) Connect the heated oxygen sensor connector and 2 clamps.
6. INSTALL CENTER EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
7. INSTALL TAILPIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Installation
8. INSPECT FOR EXHAUST GAS LEAK See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and Repair/Installation