Sequoia 4WD V8-4.6L (1UR-FE) (2010)
/Page-23001.png)
Parking Assist Control Module: Service and Repair
Installation
PARK ASSIST / MONITORING: CLEARANCE WARNING ECU: INSTALLATION
HINT
A bolt without a torque specification is show in the standard bolt chart See: Specifications/Mechanical Specifications/Standard Bolt
- Specified Torque For Standard Bolts.
1. INSTALL CLEARANCE WARNING ECU ASSEMBLY
(a) Install the clearance warning ECU to the bracket with the 2 nuts.
NOTICE:
*
Avoid any impact to the clearance warning ECU.
*
Do not drop the ECU. If it is dropped, replace it with a new one.
2. INSTALL NO. 1 ECU INTEGRATION BRACKET
(a) Install the No. 1 ECU integration bracket with the bolt and nut.
(b) Connect the ECU connectors and attach the harness clamp.
NOTICE:
Do not apply excessive force to the wire harnesses.
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Installation
4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Knee Airbag Assembly (w/ Passenger Side Knee Airbag)/Installation
5. INSTALL LOWER INSTRUMENT PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
7. INSTALL INSTRUMENT SIDE PANEL RH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
8. INSTALL COWL SIDE TRIM BOARD RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
9. INSTALL FRONT DOOR SCUFF PLATE RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and