Sequoia 4WD V8-4.6L (1UR-FE) (2010)
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
6. INSPECT IGNITION SWITCH See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/P Code Charts/P0617
NG -- REPLACE IGNITION SWITCH See: Powertrain Management/Ignition System/Sensors and Switches - Ignition System/Ignition
Switch/Service and Repair/Removal
OK -- Continue to next step.
7. CHECK HARNESS AND CONNECTOR (INTEGRATION RELAY - ECM, BATTERY AND BODY GROUND)
(a) Disconnect the ECM connector.
(b) Disconnect the cable from the battery positive terminal.
(c) Remove the integration relay from the engine room relay block.
(d) Disconnect the integration relay connectors.
(e) Measure the resistance according to the value(s) in the table below.
Standard Resistance: