Sequoia 4WD V8-4.6L (1UR-FE) (2010)
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
2. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
(a) Remove the instrument panel sub-assembly See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal.
3. REMOVE NO. 1 HEATER TO REGISTER DUCT See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
4. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
(a) Remove the 2 screws.
(b) Disengage the 2 clamps.
(c) Disengage the 10 hooks and remove the front passenger airbag from the instrument panel.
(d) Using a thin-bladed screwdriver, release the locking button.
(e) Using a thin-bladed screwdriver, disconnect the 2 airbag connectors and remove the instrument panel wire.
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT PASSENGER AIRBAG ASSEMBLY: INSTALLATION
1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
(a) Connect the airbag connector to install the instrument panel wire.