Sequoia 4WD V8-4.6L (1UR-FE) (2010)
5. INSTALL FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
7. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
Front Seat Side Airbag Assembly
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT SEAT SIDE AIRBAG ASSEMBLY: DISPOSAL
HINT
When scrapping a vehicle equipped with the SRS or disposing of the front seat side airbag, be sure to deploy the airbag first in
accordance with the procedure described below. If any abnormality occurs with the airbag deployment, contact the SERVICE DEPT.
of TOYOTA MOTOR SALES, U.S.A., INC.
CAUTION:
*
Before performing pre-disposal deployment of any SRS component, review and closely follow all applicable environmental and
hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment.
*
Never dispose of a front seat side airbag that has an unactivated airbag.
*
The airbag produces an exploding sound when it is deployed, so perform the operation outdoors and where it will not create a
nuisance to nearby residents.
*
When deploying the airbag, always use the specified SST (SRS Airbag Deployment Tool). Perform the operation in a place away
from electrical noise.
*
When deploying the airbag, perform the operation at least 10 m (32.8 ft.) away from the airbag.
*
The front seat side airbag becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.
*
Use gloves and safety glasses when handling a front seat side airbag with a deployed airbag.
*
Do not apply water to a front seat side airbag with a deployed airbag.
*
Always wash your hands with water after completing the operation.
*
An airbag or pretensioner may be activated by static electricity. To prevent this, be sure to touch a metal surface with bare hands
to discharge static electricity before performing this procedure.
1. DISPOSE OF FRONT SEAT SIDE AIRBAG ASSEMBLY (WHEN INSTALLED IN VEHICLE)
HINT
Prepare a battery as the power source to deploy the airbag.
(a) Check the function of SST See: Steering Pad/Disposal.
(b) Read the precaution See: Service Precautions.
(c) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.