Sequoia 4WD V8-4.6L (1UR-FE) (2010)
/Page-2390001.png)
Air Bag: Testing and Inspection
Knee Airbag Assembly (w/ Passenger Side Knee Airbag)
SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag): ON-VEHICLE INSPECTION
1. CHECK LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
(b) With the lower No. 2 instrument panel airbag installed on the vehicle, perform a visual check. If there are any defects as mentioned below,
replace the lower No. 2 instrument panel airbag with a new one:
Cuts, minute cracks or marked discoloration on the lower No. 2 instrument panel airbag.
2. CHECK LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT
DEPLOYED)
(a) Perform a diagnostic system check See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
(b) With the lower No. 2 instrument panel airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below,
replace the lower No. 2 instrument panel airbag with a new one:
*
Cuts, minute cracks or marked discoloration on the lower No. 2 instrument panel airbag.
*
Cracks or other damage to the connector.
*
Deformation or cracks on the instrument panel reinforcement.
CAUTION:
For removal and installation procedures of the lower No. 2 instrument panel airbag, be sure to follow the correct procedure.