Sequoia 4WD V8-4.6L (1UR-FE) (2010)
/Page-2429003.png)
(c) Disengage the guide and remove the front airbag sensor.
CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor
will cause the airbag to deploy.
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT AIRBAG SENSOR: INSTALLATION
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system
before servicing See: Service Precautions.
HINT
The procedure described below is for the LH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.
1. INSTALL FRONT AIRBAG SENSOR
(a) Engage the guide and install the airbag sensor with the nut.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
*
Do not use a front airbag sensor that has been dropped.
*
Do not subject the front airbag sensor to any impact or force.
(b) Confirm that the ignition switch is turned off.
NOTICE:
*
Do not use a front airbag sensor that has been dropped.
*
Do not subject the front airbag sensor to any impact or force.
(c) Confirm that the negative battery terminal is disconnected.
CAUTION:
*
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag
sensor will cause the airbag to deploy.
*
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(d) Connect the airbag connector.
(1) Check that the CPA is in the provisionally locked state.