Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Impact Sensor: Testing and Inspection
Side Airbag Sensor
SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR: ON-VEHICLE INSPECTION
1. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a Diagnostic System Check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
2. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
CAUTION:
For side airbag sensor removal and installation procedures. See: Service and Repair/Side Airbag Sensor/Removal and See: Service
and Repair/Side Airbag Sensor/Installation, and carefully follow the correct procedure.
(a) Perform a Diagnostic System Check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(b) When the center pillar of the vehicle or its periphery is damaged, check whether there is any damage to the side airbag sensor. If there are any
defects, such as those mentioned below, replace the side airbag sensor with a new one:
*
Any cracks, dents or chips in the case.
*
Any cracks or other damage to the connector.
*
Peeling of the label or damage to the serial number.
3. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision)
CAUTION:
For side airbag sensor removal and installation procedures See: Service and Repair/Side Airbag Sensor/Removal and See: Service
and Repair/Side Airbag Sensor/Installation, and carefully follow the correct procedure.
(a) Replace the side airbag sensor.