Sequoia 4WD V8-4.6L (1UR-FE) (2010)
(a) Remove the rear No. 2 seat assembly RH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear No. 2 Seat
Assembly (for Manual Seat Type RH Side)/Removal.
2. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (for Power Seat)
(a) Remove the rear No. 2 seat assembly RH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear No. 2 Seat
Assembly (for Power Seat Type RH Side)/Removal.
3. REMOVE REAR NO. 2 SEAT INNER BELT SUB-ASSEMBLY
(a) Remove the 2 clips.
(b) Remove the bolt and rear No. 2 seat inner belt sub-assembly.
Installation
SEAT BELT: REAR NO. 2 SEAT INNER BELT ASSEMBLY (for RH Side): INSTALLATION
1. INSTALL REAR NO. 2 SEAT INNER BELT SUB-ASSEMBLY
(a) Install the rear No. 2 seat inner belt sub-assembly.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
(b) Install the 2 clips.